-
It appears that the flying wing config only setup on one motor when it should setup 2 on outputs 1&2. Only output 1 shows the 'min throttle' setting. The rest show 0.
Output 3&4 should be the ser…
-
[Release info for version 1.4.1 states:](https://github.com/PX4/Firmware/releases/tag/v1.4.1)
> Full support for RPI2 + Navio 2 (was present for a while, now integrated / flight tested)
Full with en…
-
Im not getting any servo movement from the omnibus f4 pro board. Using the default preset for the 280 tricopter. Ive tried everything but i can not get it to work. Pleaae help
JDFPV updated
6 years ago
-
Passthrough mode produces correct control outputs.
Stabilized mode swaps the roll and pitch responses.
When the aircraft is moved on the pitch axis, a roll response follows and
when it is moved …
-
I am building a F550 Hexacopter with an Omnibus F3 v1.1 FC board. I flashed it with the latest version of INAV 1.91. My problem is, I can not get motors 5 & 6 to work. I tried motor pins 5 & 6, and al…
-
Im sorry my comment didn’t come through.
I have a betaflight f4 board and trying to get the rssi working from a l9r receiver.
I have enabled analogue rssi and tried to invert and still don’t get…
-
Currently the Multi-copter land-detector relies on thrust values which represent the actual system thrust limits with some safety margin. The hover thrust and minimum thrust are used to determine if t…
-
### Board and Version
_ Omnibus corner nano.
https://www.banggood.com/Omnibus-F4-Corner-Nano-Flight-Controller-Build-In-OSD-Current-Sensor-With-Damping-Box-IMU-p-1231552.html?rmmds=search&cur_wareh…
-
I was Getting up to 18 sats and flying well but after RC4, the GPS coordinates DO display and cycle with different numbers as if it’s trying to get a sat fix, but it never even gets 1 satellite fix. N…
-
Condition: SP3 EVO board, fully functional quadcopter with RTH failsafe procedure
**Test**
Take props away, power on the quad and the TX, arm the quad, raise thrust to about 50%, then engage Fails…