-
Hi, I want to use Stallguard and a Library to run the stepper such as Accelstepper Library. I've combined Stallguard example and Accelstepper example. Stepper is running but output is:
> 0 0 55
0…
-
I'm using a variant of the "Stallguard" example to tune the stallguard settings of my TMC 2130 SPI driver (from BigTreeTech), but I am having an SPI issue where the value for drv_status.sg_result retu…
-
Hello, Thanks a lot for this lib, I really appreciate the fact that every settings are so clear.
I was using TMCstepper lib before with accelstepper and I'am currently trying to migrate my code to yo…
-
I am using TMC2160 to drive a stepper motor with an esp32. When I try to compile the code I get an error:
Arduino: 1.8.19 (Windows Store 1.8.57.0) (Windows 10), Board: "ESP32 Dev Module, Disabled, …
-
Hi everyone, I have an issue with my newly assembled printer. I have checked the connections multiple times and couldn't find any issues with the wiring. When I try to perform Home All or Home X/Y, I …
-
# Version Number
REV04
# Bugfix or Enhancement
Enhancement
# Description
The TMC2209 stepper drivers in the Pololu stepper driver format have worked well, but they are very costly, depend on …
-
In order to greatly improve maintainability and expandability of Firmware code, a hardware abstraction layer (HAL) should be implemented in context of a big refactoring. The new architecture will then…
-
which pin z2? is the Xmax!?
/*****************************************************************************************
*********************************\* Z-axis dual driver ************************…
-
I have the same motherboard and was looking at your VS code. First question is does it work? I don't have a sensor mounted yet nor do I want filament run-out yet. Something stuck out that you have E2 …
-
Using the example Klipper configs, as well as RRF, my SPIDER KING won't detect the BIG-5160 drivers I have installed in my board.
Klipper reports:
```
INFO:root:TMC stepper_x failed to init: Un…