-
Hi!
I'm having this problem a while now. After some 'fault' event on HH (filament Runout, gate empty, etc..), my systems starts an MCU shutdown in all MCU's, usually starting by EBBCan (toolhead MCU)…
-
I upgraded my Voron 2.4 with Chaoticlab's Carbon Fiber Gantry kit (A-B motor mounts + XY gantry mounts with 2020 extrusions) and CNC Tap V2. The Carbon Fiber Gantry kit doesn't support X & Y limit sw…
-
I see the wiring diagram for SSR with Octopus, but where do I plug those wires into my Gold SSR?
![s-l400](https://user-images.githubusercontent.com/62305236/128616981-e281e151-55a1-4ef8-9e81-e67fc…
-
I am looking for a way to reverse filament direction based on active tool selected. T0 and T1 use the default loading and unloading procedure. However, when switched to T2 and T3, the filament runs on…
-
### Version
2.4.58.5
### Operating system type + version
Win10
### Behavior
When using the Voron Calibration cube on the platter, it places it ~15mm lower than it should, so the bottom 15mm o…
-
Greetings!
I just came across your MOD over on the Voron MODs page and was quite intrigued because of my Setup since I'm running _even heavier_ than [Stock LDO-42STH60-3004MAC (S40) Stepper Motors]…
-
I keep getting errors:
Section 'autotune_tmc stepper_x' is not a valid config section
Here is my config section:
```
[autotune_tmc stepper_x]
motor: ldo-42sth48-2004mah
[autotune_tmc ste…
-
Looks like you may have mixed up the file names. "Classic" spool holder that looks like the Voron "Classic" holder, doesn't match up with the "Classic" named files, the BB files appear to have the ma…
-
Hello,
Is it possible to upload symmetric skirt without HBB for 300 version? As the versions i found are not having same looks
For 350mm i see you uploaded versions with Knomi, can the same be…
-
I installed Chaoticlab's Carbon Fiber Gantry Kit (AB Motor Mounts + XY Gantry Mounts on existing 2020 extrusions) along with Chaoticlab's CNC Tap V2 on my Voron V2.4. As the Carbon Fiber Gantry Kit d…