-
```
What steps will reproduce the problem?
1. Boot Arduino
2. Log pages are iterated
3. Select 3 to exit logmode
4. Code waits for slider to be switched which does not exist on the
non-shielded mega.…
-
It takes a really long time to determine that it's landed. I have broken countless props, trying to disarm when landed only to have the thing flip over because it thinks I am applying yaw. The most re…
-
```
Which board (stock / gruvin9x / sky9x) are you using?
stock
What is your open9x FW version?
R1563
What is your open9x EEPROM version?
What steps will reproduce the problem?
When I switched from …
-
```
What steps will reproduce the problem?
1. Boot Arduino
2. Log pages are iterated
3. Select 3 to exit logmode
4. Code waits for slider to be switched which does not exist on the
non-shielded mega.…
-
```
What steps will reproduce the problem?
1. Boot Arduino
2. Log pages are iterated
3. Select 3 to exit logmode
4. Code waits for slider to be switched which does not exist on the
non-shielded mega.…
-
```
Which board (stock / gruvin9x / sky9x / Taranis) are you using?
stock (Turnigy 9XR with ATmega 128; BOARD_M128)
What is your openTx FW version?
opentx-9xr128-heli-templates-nosplash-battgraph-t…
-
```
For safety on ground it is paramount to know whether the motor controls are
armed or not armed. As per default it is only signalled on the APM board on a
little, in many installations partly hid…
-
```
What steps will reproduce the problem?
1. Set the mode switch to FBW_A at any point.
What is the expected output? What do you see instead?
Expected output: Control surfaces should respond to iner…
-
```
I loaded my 1280 mega board with the latest v2.5.3 firmware with the APM planner
The problem which I am facing is that when I arm motors and increase throttle
till just the position where the mo…
-
```
I loaded my 1280 mega board with the latest v2.5.3 firmware with the APM planner
The problem which I am facing is that when I arm motors and increase throttle
till just the position where the mo…