-
Hi, my fixed wing, a fly wing has a problem, I put it on the table and set the pitch slope and leaves the closest to zero, and then it always flies nose down, then I decided to install the new firmwar…
-
Not sure if this is a hardware or code issue but it goes as follows:
Me and two other guys have been experiencing heavily fluctuating current reading in iNav when motor is running. This has been going…
-
After updating to iNav 1.8 RC2 when I fly more than 1000m, the distance to home in the OSD disappears. It reappears when I return to less than 1000m from launch. I have updated the fonts and did not h…
-
hi i use pixhawk with traxxas stampede(rover,rc car).
but rover only forward
How do i get car reverse??
I use https://dev.px4.io/en/airframes_experimental/traxxas_stampede.html
-
Did some tests with MSP_RX in inav 1.6.1, it seems, the throttle channel is not returning to zero in case of "lost signal".
Steps to reproduce:
- Move channels 1-4 to "full-throw" (so that they sh…
-
I followed the instructions provided. I'm running arducopter with no parameters and getting a "No INS backends available" error:
```
root@beaglebone:~# ./arducopter-3_5_0
DataFlash_File: buffer …
-
The other day I lost a flying wing after losing the RC link. The wing was configured with failsafe_procedure = RTH, but it went down instead. Thanks to some partial frames I got from video feed and th…
-
Hello.
I ask you here because i gave a problem with my revolution :
- my op gps works only with the main port, not work with the flexi port, do you know why?
- I need to use the main port for put …
-
output number 4 (right elevon) has more deflection (about 200%) on ROLL and PITCH through input from transmitter. When in any stabilized mode, the deflection on both surfaces is the same.
Could th…
-
Today I tried version 1.7.3 and catch this problem. Situation looks like below:
- sometimes when model lost RC link - RTH failsafe is detected correctly and model come back to home, clibm if needed…