-
During initial configuration one sometimes runs into issues where it would be desirable to disable the min/max temperature checks so that one could continue testing/troubleshooting during initial setu…
-
During the team discussion of 20240116, we spoke about the maximum current into the heaters which the Control Assembly might provide into the incubator heaters. Each of the heating pads (Sparkfun COM…
-
I am running ercf on a custom Delta printer. When a clog is detected, or there is no filament in the cart, I will get a "Move out of range" error when the printer goes into the pause state. I have tri…
-
### Describe the bug
Title. You can build these on certain furnitures, I think non-appliance ones.
### Attach save file
[Wooldridge-trimmed.tar.gz](https://github.com/CleverRaven/Cataclysm-DDA/file…
-
### Is there an existing issue for this?
- [X] I have searched both the existing open issues & recently closed issues and did not find a duplicate of this issue.
### Version of the Tesla compone…
-
I just purchased one of these from your ebay store. Do you have the code setup for ESP Home that you could provide? I am planning on using this with home assistant.
-
When my delta homes it will stop one or more axes short of the endstop, then does its back off, and on the retest it starts for the endstops again but often (not always) stops short. In the end, some…
-
to do:
-create bill of materials with budget$$ cap: $1,500 (James how is that looking?)
-submit proposal to BSCIT Fund (How long is this process? I can help here!)
-build the thing! (James + kelly + d…
-
Buying an `€800k` Farm+Forest https://github.com/dwyl/phase-three/issues/144 might be overwhelming for @iteles right now. 💭
But our _immediate_ challenge is childcare. We've wanted to create a playg…
-
Hi there,
I am using your `mkuf/klipper` Docker image for my Docker-based Klipper setup on a Raspi 4. Starting with a recent upgrade the container started crashing when my 3D printer becomes idle a…