-
After many hours of troubleshooting, I still can not read encoder counts on pin 2 and pin 3. I have tried different uno's, different encoders, looking at the encoder pwm with an oscilloscope, reading …
-
Hi,
I'm running Grbl on an Arduino uno (tried 0.9a and 0.8c) with the same results. Axis X moves back and forth, Axis Y moves one way only.
Tried already reversing the wiring, reversing one phase, 2…
-
With the Steele PDB I was not able to flash the new firmware, neither on Mac or Windows. On Windows this issue was probably related to my updates being turned off. So I plugged the board in the window…
-
I have been unable to reliably read data from the pololu AStar 32U4 SV stacked on top of a RPi 3 B. I have a minimal case, and have reproduced it on multiple boards. In my minimal case, I send a singl…
-
i am new at this sketch for my zumo. when i added this program into ardunio code and did the analyzer it said 'Zumo32U4.h' file not found. will this be ok to down load onto my robot.
-
I'm very interested in trying g2core as a replacement for my current LinuxCNC setup but am not quite enough of a computer geek to start from scratch compiling the latest master branch myself. The pre-…
kitwn updated
6 years ago
-
-
Hi, I'm currently using Arduino MEGA 2560 with AltIMU-10 v5 but it is currently nt showing me any output values in Arduino Serial Monitor. Any idea why?
-
I've been having great success getting Johnny Five to work with the Zumo bot. Motor control through wireless works great with keyboard control.
I'm now trying to get the attached IR Array to work.
…
-
After following the README, installing, and saying
```
hr run robot
tmux a
```
When I switch to terminal 3, I see the error message:
```
bash: line 0: cd: /opt/hansonrobotics/tools/blender: N…
linas updated
6 years ago