-
Hi all,
I've found what appears to be an issue with the px4 v5 firmware in (as far as I can tell) any fixed wing configuration, that prevents you from arming the motor. I first encountered this iss…
-
```
What steps will reproduce the problem?
1. No overlay at all
2. video is ok from GoPro
3.
What is the expected output? What do you see instead?
I am only getting video from OSD. No overlay whatso…
-
```
What steps will reproduce the problem?
1. No overlay at all
2. video is ok from GoPro
3.
What is the expected output? What do you see instead?
I am only getting video from OSD. No overlay whatso…
-
```
What steps will reproduce the problem?
1. No overlay at all
2. video is ok from GoPro
3.
What is the expected output? What do you see instead?
I am only getting video from OSD. No overlay whatso…
-
```
What steps will reproduce the problem?
1. No overlay at all
2. video is ok from GoPro
3.
What is the expected output? What do you see instead?
I am only getting video from OSD. No overlay whatso…
-
When connecting multiple uavs the connection name in the upper right hand corner does not change.
This has been tested with APM Planner 2.0.20 on Ubuntu 15.10 with two uavs connected via udp (throug…
-
```
What steps will reproduce the problem?
1. No overlay at all
2. video is ok from GoPro
3.
What is the expected output? What do you see instead?
I am only getting video from OSD. No overlay whatso…
-
### Describe the bug
The first problem with hitl was observed in the Airsim simulator when upgraded to the 1.14 version of PX4. Until that with 1.13.3 version Airsim worked just fine ( had a problem …
-
i was testing to see if the esc calibration is OK ( I used a pixhawk board on DJI s1000 vehicle)
the motors didn't start until after 50% throttle
after that i couldn't disarm
i tried many times b…
-
I just updated to the newest GitHub Mavproxy version but still I have a strange behavior during log downloads via Mavproxy. (I use a linux machine)
The first 97% of the logile is downloaded very fast…