-
Just leaving the phone connected to the t-beam results in it loosing connection.
The app is ver 0.1.2
board is running 0.1.0
Close to the end of the logfile there is
03-08 16:12:57.329 42…
-
### Board and Version
Omnibus F4 (https://www.banggood.com/Betaflight-F4-Flight-Controller-STM32-F405-MCU-Integrated-OSD-p-1103940.html?rmmds=myorder)
INav 1.9.2
INAV/OMNIBUSF4 1.9.0 Mar 21 201…
-
## Current Behavior
Case 1: When flashed OmnibusF4V3 target to F4V3 board, PPM is working on SBUS/PPM pin.
Case2: When flashed the same board with Omnibus F4V3 S5S6_SS, Omnibus F4V3 S5_S6_2SS or Omn…
-
### Basic Infos
#### Hardware
Hardware: ESP-12F Devkit V3 from [Banggood.com](https://www.banggood.com/Geekcreit-Doit-NodeMcu-Lua-ESP8266-ESP-12E-WIFI-Development-Board-p-985891.html?rmmds=myo…
-
**Hey googlers! Using F.Port on your FrSky receiver would probably be a better option if it supports it. Solder to the Uninverted SmartPort pad and then flash it to F.Port through your radio. It shoul…
-
**Describe the bug**
I have the Mateksys M8Q-5883 compass(QMC5883L)/gps installed on version 4.1.6 install of betaflight. The board does not recognize any magnetometer connected.
**To Reproduce**…
-
We need to figure out how the remote control works and what alternatives we have.
- How easy is it to integrate?
-
Hi,
I have been stuck on problem since I introduced an external micro SD adaptor/drive to my design. My design has the following components:
1. KeeYees ESP32 ESP-32S Development Board
2. HiLetgo…
-
Hi there, first of all thanks for the library it is really useful.
I'm using the NodeMCU Amica with this oled screen : https://www.banggood.com/1_5-Inch-128x128-OLED-Shield-Screen-Module-For-Raspbe…
-
Hello,
I'm using the software to emulate some temperature sensor using low cost xiaomi devices. From my test not all commands sent to the evohome devices need to get an acknoledge. For example this…