-
On 1.6.0rc1 the actuator controls are all zeros coming out of the pixhawk. Controls are zeroed when commands originate from the pixhawk (in stabilized/hold mode) and under manual control (using a rece…
-
* Seen in version (release version or githash): b48a5b5227fb57e6584cda18e68e446c6dc4dcdb
* On flight controller (if applicable): RE1
Issue details:
Trying to configure a flying wing with eleon …
-
# 3. If you answered NO to the first question. Delete everything above this line, read the guidelines (see link above this form) and continue.
# A - Description
SP Racing F4 Evo isn't moving an…
-
- Fixed wing differs from multi-rotor in that channel reversing from a parameter standpoint is dictated by servo setup. Currently RC cal sets parameter channel reverse based on PWM values. This is cor…
-
This is for the stage 1 prototype, this prototype needs to be inexpensive and relatively easy to build. We need to figure out how we are going to actuate it without using too much power, and without m…
-
Seen in CI during `docker start`:
```
Error response from daemon: Server error from portlayer: unable to wait for process launch status: context deadline exceeded
Error: failed to start containers:…
-
release estimate: mid-august
expected:
- new packages:
- python-3.6.3, python-3.5.4
- spyder-notebook, spyder-terminal, spyder-reports
- Vitables for Qt5.5+, moviepy, brotli,
- da…
-
In Betaflight It can Auto detected and read fine. But in Inav its not auto detected.
Also, when I set manually `set baro_hardware = MS5611` the CPU load rise to about 660%
![screenshot from 2017-04-…
-
Hello Adafruit,
after checking into most forums and validating a few theories on the facts at end--> When used with the Adafruit M0-Winc1500 feather board the PCF8523 RTC looses time on power loss (…
-
Quite a while ago (before going to airplanes) we removed `emf_avoidance` option. But F1 and F3 chips run at 72MHz, 6-th harmonic of which is 432MHz. This may cause issues with LRS operating in that ba…