-
### Describe the bug
Using a Non PX4 CAN Node GPS, such as the Holybro DroneCAN F9P (Uses AP Periph). These Parameters that are required for CAN GPS Heading are not available in the **Component ###…
-
- [x] 13760 VTOL fwd motor (@priseborough )
- [ ] 13961 IMUO serial protocol (@tridge)
- [x] 19517 Add OSD_TYPE2 (@yaapu )
- [x] 19687 Send gps over DroneCAN (@magicrub )
- [x] 20138 LD-06 Proximi…
-
`dron@dron-VirtualBox:~/ardupilot/ArduCopter$ sim_vehicle.py --console --map
SIM_VEHICLE: Start
SIM_VEHICLE: Killing tasks
SIM_VEHICLE: Starting up at SITL location
SIM_VEHICLE: WAF build
SIM_VEH…
-
Hello! I'm trying to us IQ Control Center (IQCC) to flash a 40-06 module with its newest position firmware ([available here](https://www.vertiq.co/40-06-g2)), however I keep getting an error before th…
-
Good day @rmackay9, @Georacer and @tridge!
Much respect for your work.
I have an `icm-20948` sensor and a `stm32f411ccu6` microcontroller
I know that the `Ardupilot` for the entire project requires…
-
I run the command make "px4_sitl jmavsim", it failing and giving below error I tried all solution on the internet nothing worked.
-
I'm running into an issue with flashing. Following the [instructions](https://arkelectron.gitbook.io/ark-documentation/flight-controllers/ark-jetson-pab-carrier/updating-the-flight-controller), the fl…
-
This is a dronecan application firmware that is hard faulting after the bootloader updates firmware (there is nothing occupying flash space after the bootloader). The near exact board config worked wi…
-
I was trying to build bootloader for experimental AP_Periph board, but build was failing.
```
Traceback (most recent call last):
File "/vagrant/modules/DroneCAN/libcanard/dsdl_compiler/libcanard_…
-
**Describe the bug**
I am trying to use Here 3 GPS with Cube Orange running PX4 1.11.3. I followed the Cube Pilot [docs](https://docs.cubepilot.org/user-guides/here-3/here-3-manual) to setup both the…