-
## Список необходимого
#### [Самодельные детали](https://github.com/Morn91/Slider/issues/1#issuecomment-96765375)
> - **3** детали делаются на фрезерном станке
> - **4** одинаковые детали — на токарн…
-
Hello, i just installed the 1.22 release.
During the compilation, i had some warnings but i was able to start it. The application seems to not have access to the GPIO (i made tests on lasers and moto…
-
Is this also compatible for the DRV8834?
-
альтернатива https://github.com/rusefi/rusefi-hardware/issues/187
вариант, если документация https://www.ti.com/lit/ds/symlink/drv8834.pdf?ts=1690993323931&ref_url=https%253A%252F%252Fwww.ti.com%25…
-
**Describe the bug**
Turn the stepper 200 steps clockwise, then 200 steps counterclockwise. Repeat. After a minute or so one can see the shaft home position creeping in one direction. Same behavior…
-
**Describe the bug**
The code is aimed to move a motor 1 forward, then, move a motor to forward and back, then, move the motor 1 back.
**To Reproduce**
Steps to reproduce the behavior:
1. #inclu…
-
```
The Marlin version RC7 - 31 Jul 2016
Machine Self build coreXY
Electronics board ramps 1.4 with arduino 2560
Machine components (direct drive e3d lite, with termistors (my stepper drivers are m542…
-
Things need to be done for motor testing:
1. Test if phase mode works with Arduino, DRV8834 and the stepper motor. (tested to be working with pay-ssm)
2. If the phase mode works, test see if it prov…
-
Since the old thread is closed....
My SKR 1.3 arrived today. Look forward to getting it working over the weekend. I know some pins have changed and I'm still not sure if they fixed the LCD cable or…
-
### Hardware:
Board: ESP32 DevKitC V.4
Core Installation version: (recent??)
IDE name: Arduino IDE (1.9.0)
Flash Frequency: 80Mhz
PSRAM enabled: …