-
- Shunts
- Feedback-Networks (for example battery voltage measurement)
- Setpoint resistors for current sources
-
(for now use 10 instead of 8: e.g. 10 mbps ≅ 1MB/s)
-
### The problem
The sensors provided by this integration cannot be adjusted in the UI and are therfore incorrectly displayed.
I would like to change the unit of measurent of these sensor (e.g. temp…
-
Would be great if this supported calculating LAeq.
Currently using `maad.spl.wav2leq()` but would like to get an LAeq value, if possible.
> ‘A’ Weighting is a standard weighting of the audible…
-
### What are you missing?
**Success notifications (Toasts)**
Usage: Triggered after successful completion of each task
- [ ] Project creation and editing
- [ ] Experiment creation and editing
- [ ]…
-
Steps:
1. Visit https://speed.cloudflare.com/
2. Wait a few seconds.
Expected: packet loss test runs.
Observed: packet loss test fails with this error:
> Unable to perform measurement: Ty…
brcsw updated
12 hours ago
-
Hi! I'm having an issue with using PEtab with Catalyst, and I think there's something going wrong in the residual calculation. I can set up the problem as in the docs, including with data taken from a…
-
Use case: I'd like to combine footnotes from this package with [`ShortCodes.jl`](https://github.com/hellemo/ShortCodes.jl/tree/main)'s `DOI` to do something like:
```julia
md"""
As discussed in […
-
[VNA_POW.txt](https://github.com/scikit-rf/scikit-rf/files/11345105/VNA_POW.txt)
I use a program-controlled VNA to perform power sweep measurements. I set the software to measure S-parameters from …
-
# Description
Importing the `Network` class takes quite some amount of time depending on the platform and hardware. Below are some examples:
| Linux NUC | MacBook Pro | Windo…