-
Hello,
Could you please let me know the interface from ptGrey GigEVision Blackfly camera to jetson tx2 board?
Is it using the ethernet interface?
-
**Describe the bug**
I see occasional corruption artefacts in images taken with Aravis from a PtGrey BlackFly GigE camera. These are visible as one or a few horizontal stripes of mismatching color in…
ghost updated
4 years ago
-
ptgrey camera settings is set up only on ptgrey camera node start.
If we connect the camera after node has started, then its' settings will be default (auto exposure, etc.)
If the camera is reset for …
-
I set up my two Blackfly cameras according to the following instructions using the correct GPIO cables: https://www.ptgrey.com/tan/11052. What steps do I need to follow to enable time syncing using t…
-
when i run the command " roslaunch pointgrey_camera_driver camera.launch", i meet the warning:
Warning: Default Linux receive buffer setting is lower than expected. You may experience poor GEV stream…
-
The installation from PointGrey for the arm platform is incomplete. The instruction only tell user to copy the content of `SDK/lib` folder to `/use/lib`. Where as the content of `SDK/include` need to…
-
Because of bandwidth limit in usb hosts, it cannot use dual camera
but, some configuration for solve this problem [ref link](http://stackoverflow.com/questions/9781770/capturing-multiple-webcams-uvcv…
galch updated
9 years ago
-
The node runs perfectly but doesn't publish any images please help. The sdk GUI detected the camera as well and we were able to publish images using camera 1394 drivers.
-
Test with color images. Just a global check that everything works with color images
-
Now I have two blackfly cameras. I want to run them in ROS and trigger them with software. Does anybody know how to do it? Thank you!