-
If you do not mind May I get your e-mail contact information mainly related with "https://www.youtube.com/watch?v=hhzmJQi04Rc&feature=youtu.be ". Kevin from ROBOTIS. (kevin.lee@robotis.com)
-
DYNAMIXEL XH430-W350-R 토크 제어 https://emanual.robotis.com/docs/en/dxl/x/xh430-w350/#operating-mode11
-
Hi,
Hi,
robotis-op2 has 4 FSR sensors for each foot.
However, I dont know left_fsr_x and left_fsr_y . What are LX : Left foot center point of the X-axis force,LY : Left foot center point of…
-
Hello~
When I executed roslaunch op2_manager op2_manager.launch, the problem appeared as shown in the figure. However, I changed the pin line of the robotis-op2 camera and the motor control line, …
-
### System Info
```Shell
lerobot's low cost hardware configuration: Waveshare Serial Bus Servo Driver Board will brick the servo when update the firmware of servo
```
### Information
- [X] One of …
-
Is there a chance to have an updated version of the model in respect to meshes and especially the geometry.
I have a new version which robot arm looks like this https://emanual.robotis.com/assets/im…
-
Hello sirs,
I am trying to get the gazebo simulation working but it seems to run into an issue. The simulation loads but then does not work. I have attached the terminal outputs below. Sorry if thi…
-
Is there a way to get access to Robotis Op2 without the hdmi port? If not, what should we do about the port.
-
When you try to install release 1.5.3 on Arduino by doing:
1. Go to Preferences --> add URL
https://raw.githubusercontent.com/ROBOTIS-GIT/OpenCR/master/arduino/opencr_release/package_opencr_index…
-
Some Dynamixel motors spawned in our closet. This package has control boards that we can utilize. Begin working with these controls and interface with raspberry pi.