-
Hi everyone
does this library support sx1268?
Thanks
-
Hi, would it be possible to add support for the heltec v3 board. I understand it uses a sx1268 chip
-
**Describe the bug**
The SX1268 does not turn on. The serial output shows that communication with the chip does not occur, as the frequency setting nor gain settings at startup apply. Additionally it…
mph88 updated
7 months ago
-
Bei der Bestellung der Boards des Lora T-Beams habe ich zwar auf die Frequenz 430MHz geachtet, aber den Unterschied von SX1278 und SX1268 leider am Handy nicht gesehen. Nun habe ich jetzt hier SX1268 …
-
Hi,
The docs mention support for the "TTGO T-Beam V1 (433MHz SX1278)". Is the 1.1 version of the board also supported? Those seem to be the only ones i can buy on AliExpress. [Link](https://nl.alie…
-
I am using Ra-01s AI Thinker and using sx1268 but the following error occurred ERR_SPI_CMD_FAILED. MY pins configuration would be
`sx = SX1268(spi_bus=1, clk=18, mosi=23, miso=19, cs=5, irq=26, rs…
-
### Description of the issues
硬件平台 树莓派4B 系统为烧录工具推荐的 易佰特 lora模块 E22-400M30S SPI链接
![image](https://github.com/hepingood/sx1268/assets/24492495/ea7d04b9-6cb1-4e0b-967d-18b0e335dc25)
![image](https:/…
-
I am trying to communicate two devices. One broadcasting based on Ra-02 Aithinker SX1278 433MHz using arduino-LoRa library (demo sender).
https://www.disk91.com/2019/technology/lora/first-steps-with…
-
Error if send from bluetooth: failed, code -705
Receive not work (len off)
My config
```
#ifdef ESP32_DIY_1W_LoRa_GPS // My Ebyte E22 400M30S OR RA-01S / SX1268
#define OLED_SDA …
-
Hi,
I have TTGO T-Beam V1.1 which has SX1262 LoRa module.
The module fails to initialize and isn't supported with the builtin templates.
To make a long story short, here is how to solve it (not ele…