-
I'm wondering what you're using to connect the thermocouple wires to the PCB? The space looks pretty tight given the components on the top side of the board. Do you have some terminal block arrangem…
-
The SB2240 Build manual specifies GH1.25 connectors for many of the board side connectors, like the TH0 thermocouple connector, etc.
GH1.25 connectors do NOT mate.
Discord notes that they are Mo…
-
Thermocouples are needed where dissipation or environment prevent the use of NTCs, RTDs, and diodes
* use the special connectors, which are type-dependent, aim for K-type by default
* common refer…
-
One could design a custom power module for DIOT with the following features:
* 220mm depth, 8HP/10HP wide (maybe 9HP, see below), ~offset green guide like EEM_PWR_MOD_AC~ 1HP offset red 220mm guide…
-
### Goal
To have an initial, breadboarded HW prototype ready to enable code development
### Steps
- [x] Research thermal sensing options, select and source
- [ ] Select dev platform (MCU, …
-
Hi,
long time since something happend here. Hope i'm not disturbing the silence :)
Got my setup a while ago and wanted to resume roasting...
TC4Shield + Arduino UNO
via USB to Artisan Roaster Sc…
-
Quartz tube or reaction chamber: where chemical reactions take place at high temperatures.
Heating system: an electric furnace or induction heater to heat the quartz tube.
Gas supply system: gas cyl…
-
**Describe the issue**
I have ThingsBoard Gateway installed on a Raspberry Pi 4 with 8GB of RAM, to which I have connected a serial device that measures the temperature through three thermocouples (I…
-
# GUIDE:
1. You CAN NOT mix PT100/PT1000 and thermocouples:
If you have only one hotend then you can have the following:
- Thermistor (that is an ADC Temp Sensor [uses a pure analog I/O pin]…
-
# Thermal sensing for LV3.
### Description
The temperatures that the airframe will experience -- namely at the motor mount and the tip of the nose cone -- are a bit of an open question. It would …