-
Hi,
Encouraged by similar request #34 I decided to add a new issue. I'm looking forward to create a new design using attiny204 (alas, nothing else is left on Mouser!).
I'm assuming that 0-series s…
-
I'm interested in adding support for the new AVR chips, 0/1/2-series tinyAVR and megaAVR, that have been released in the past few years. While overall the cores look a lot like classic AVR cores, ther…
-
And here we were all worried that Microchip was going to let AVR languish, and was just doing a capture -> woodshed sorta thing to take out a PIC competitor...
Microchip's AVR team has apparently …
-
The tinyAVR 0/1 series are supported by avr-libc (development version, no release yet), thus the "proprietary" Atmel DFP isn't necessary.
In the past one was able to fake its existence by setting a…
-
What kind of issue is this?
- [ ] **Feature Request**.
This is a feature request, I guess!
There is a series of new AVR chips from microchip, like attiny804.
A nice list of them is in this art…
-
This library will provide the following functionality:
* Allow sleep where the RTC is used to keep time in standby sleep, and adjust millis() time upon wake, when using any timer except RTC as the …
-
I'd love to see the ability to program the fuses for the relatively new tinyAVR 0/1/2 and Atmega series (like mega3208/09, mega4808/09, AVR128DBxx. I use AVRDUDESS regularly for "mass" flashing (haha,…
-
Maybe not an issue, but why do you do this?
```
/* Enable all UPDI port pull-ups */
PORT(UPDI_PORT) = 0xFF;
```
```
/* Enable all LED port pull-ups, except for the…
-
Hi,
I can Flash and read the FUSEs but when I try to set a fuse it always fail with the error below.
```
ze-mac:device ze$ pyupdi.py -fs 0:0x00 -c /dev/cu.SLAB_USBtoUART -d tiny202 -b 115200
Dev…
-
Hello,
Is possible to support the attiny1614 more (ram/flash) ?
I get errors in make because the "USB_INTR_PENDING_BIT":
sbdrv/asmcommon.inc: Assembler messages:
usbdrv/asmcommon.inc:99: Error:…