-
### Version
0.8.0 (current)
### VenusOS version
3.50
### Does this issue occur during installation or at runtime ?
Runtime
### Is there a Discussion thread for this issue? Please pas…
-
When more than one battery is connected in parallel and the JK-BMS (Inverter type) is connected to Venus via BMS.Can, polling the master BMS for data causes the comms between the batteries to be lost …
-
If there are multiple VE.Bus systems present, the Marine app uses data from the wrong system.
This applies to the AC input, AC load and device controls (mode and input current limit).
The logic to…
-
Hello,
i have a Shelly PRO 3EM and VenusOS 2.93 running on a Beaglebone Black. I have managed to install the GEN2 driver and configured the Shelly to send the values via websocket to the Beaglebone…
-
Hello, I own an inverter that is compatible with mppsolar and uses PI30 . But the device is listed as hidraw0 instead of ttyUSB0 . Help me on what i can change to make use of your script .Thank you.
-
I've installed the Rikkert-RS package to get temperature of the CPU and additional DS18B20 temperature. Recently I was hoping to add relays to the system by installing RpiGpioSetup.
RpiGpioSetup wor…
-
Hi,
Thanks for your effort! I am currently using your Code for a home solar project including a battery bank with chargery bms.
Would it be possible to monitor a second BMS with an additional FTDI…
-
Hi!
After some investigation I could isolate the reason, why dbus-mqtt in VenusOS is dying constantly with the following error message in /var/log/dbus-mqtt/current:
```
@400000006352c6dd24b60c64 I…
-
Hi,
happy to find finally something to get my JK into VenusOS so many thanks!
I can see the BMS but i get the following error when i try to connect.
INFO:BluetoothBattery:Connected C8:47:8C:E…
-
Hello,
Can is working but every reboot I notice this line in logs (dmesg). Is something wrong with the script or I have something messed up with my specific configuration?
Any ideas?
Thanks i…