In this repository you will find a small project that implements the NTP Server
. Date and time are synchronized through GPS
, accuracy is achieved by means of PPS
. Devices can work by WiFi
andEthernet
.
GPS <-> WT32-ETH01
-----------------
GND --> GND
Tx --> PIN35 (Rx)
Rx --> PIN17 (Tx)
PPS --> PIN33
VCC --> +5V
TFT <-> WT32-ETH01
-----------------
GND --> GND
VCC --> +5V
BLK --> +5V
#MISO --> PIN36
MOSI --> PIN15
SCLK --> PIN14
DC --> PIN4
CS --> PIN12
RST --> PIN2
Select connection mode. Choose suitable for you.
//#define OPERATE_AS_AP
//#define OPERATE_AS_STA
//#define OPERATE_AS_ETH
In the case of a wireless connection, specify the ssid
,pass
Since this device doesn't take leap seconds into account, the 'correct' time will be calculated with a simple offset.
This offset affects the microsecond counter so fine control can be achieved.
NOTE that this only ever can be a positive number!
#define TIMING_OFFSET_US 0001
Do NOT run your data center from this device! Go and buy a proper NTP server with an atomic clock in it!
There is no leap-second check and fine tuning is done via a manual set in a #define
directive. If you decide to use the device in wifi client mode, the timing accuracy will also depend on the network the device is working on.
The timing data might be erroneous when the 32-bit microsecond counter value overflows (which happens every 71.583 minutes), or when the GPS decides to send back garbage data due to incorrect information or weak satellite signal.
Nothing checks whether the GPS data is actually realistic, so if you see on the display that it's 18th of January 1972 or 9th of May 2025, this is the time and date the NTP server will report.
According to my measurements, the achievable timing accuracy is about +/- 50 milliseconds 90% confidence interval when the offset is adjusted correctly.
Sometimes, when the server is processing packets rapidly due to hammering, an extra second delay might be introduced. A normal output with sntp
should be something like:
$ sntp 192.168.4.1
sntp 4.2.8p10@1.3728-o Tue Mar 21 14:36:42 UTC 2017 (136.200.1~2544)
2019-03-07 16:14:05.328536 (-0400) +0.010 +/- 0.008126 192.168.4.1 s1 no-leap
$ ntpdate -q 192.168.4.1
server 192.168.4.1, stratum 1, offset -0.000596, delay 0.02802
2 Mar 19:13:38 ntpdate[92566]: adjust time server 192.168.4.1 offset -0.000596 sec
If you see that the +/- deviation is in the range of a few hundred milliseconds, try syncing time again until you get a few milliseconds like in the example above.
It is worth noting that the output of information on the screen is not a priority. Accuracy of readings may be unreliable.
https://github.com/ldijkman/WT32-ETH01-LAN-8720-RJ45-
https://github.com/kosma/minmea
https://github.com/UT2UH/PPS-ntp-server
https://github.com/ha5dzs/PPS-ntp-server
https://github.com/DennisSc/PPS-ntp-server
https://wiki.iarduino.ru/page/NMEA-0183/