beast2_constsites: Update BEAST2 XML to account for constant sites
Introduction
Based on this suggestion by Remco,
we can correctly account for constant sites in a BEAST2 analysis by adding the
following data tag below your current data tag:
<data id="xyz" spec="FilteredAlignment" filter="-" data="@xyzOriginal" constantSiteWeights="100 200 300 400"/>This assumes that your original <data> tag had id=xyz and was renamed
to id=xyzOriginal, and that you have 1000 constant sites that were
removed from the alignment, with:
- 100 As
- 200 Cs
- 300 Gs
- 400 Ts
Other phylogenetic software allow you to also account for constant sites if
you are only supplying an alignment with variable sites. As of version 0.3.0,
beast2_constsites also supports IQTree as well as
BEAST2.
If you would like support for other tools, please file a GitHub issue, and specify how the tool would require the information.
What does this do?
BEAST2
This script will take a FASTA file with a single DNA sequence (e.g., a
bacterial chromosome), a VCF file containing the position of
SNPs along the FASTA file (e.g., as outputted from snippy-core)
and the XML file produced by BEAUTi containing only variable sites. It will
output a new XML file named <original_xml_name>_plus_const.xml with the
added information to account for constant sites. There is nothing else you
need to do but run BEAST2.
It will optionally also take a BED file with positions to mask (e.g., positions of phage).
IQTree
beast2_constsites will take the same FASTA, VCF, and optionally the BED file,
as described above, and will print out the iqtree command's -fconst option
with the appropriate numbers and format. You can then copy paste the relevant
portion to form the complete iqtree command.
How to install?
pip3 install b2constsitesHow to run it?
If installed correctly, a scripted called run_b2cs should be available in
your path:
run_b2cs --helpBEAST2
At a minimum, you need to supply a sequence file with your reference (assuming it has a single chromosome entry --- this was designed for bacterial genomics, but may work with viral too), a VCF file with variants, and the XML output from BEAUTi.
run_b2cs -x myxml.xml beast2 myref.fasta myvar.vcfA new file called myxml_plus_const.xml will be created in the same folder as
myxml.xml.
IQTREE
At a minimum, you need to supply a sequence file with your reference (assuming it has a single chromosome entry --- this was designed for bacterial genomics, but may work with viral too), and a VCF file with variants.
run_b2cs iqtree myref.fasta myvar.vcfASSUMPTIONS and CAVEATS
This script will:
- Only take in to account SNPs and MNPs annotated in the VCF. Other variant types will be ignored.
- Will only take into consideration A, C, G, and T bases in your reference sequence. All other characters will be ignored.
- Has not been tested with BEAST1.8, and as far as I know it will not work with that version of BEAST.
The output will be, therefore, an approximation. However, it should be a close enough approximation that it will provide a better inference from BEAST2 and IQTree than if one uses only variable sites, and then corrects in some post hoc manner.
Authors
Anders Gonçalves da Silva
Sarah Baines
Jean Lee
Torsten Seemann
Maintainer
Anders Gonçalves da Silva