mageshms arducopter issues

mageshms / arducopter

Automatically exported from code.google.com/p/arducopter

0 stars 0 forks source link

issues

Newest

Newest Most commented Recently updated Oldest Least commented Least recently updated

r2521

#191 GoogleCodeExporter closed 8 years ago
2
Manual update to include "damp APM with foam" recommendation

#190 GoogleCodeExporter closed 8 years ago
1
APM Planner shows incorrect values for PID

#189 GoogleCodeExporter closed 8 years ago
8
ACM2 Firmware Fails to Load but other Firmware Will Load

#188 GoogleCodeExporter closed 8 years ago
4
manual update re bullet connectors

#187 GoogleCodeExporter closed 8 years ago
1
Tricopter servo yaw issues

#186 GoogleCodeExporter closed 8 years ago
22
Megaplanner does not report motor 5 output. (Hexa setup)

#185 GoogleCodeExporter closed 8 years ago
10
Megaplanner GCS Mavlink flight status does report Ardupilot ones

#184 GoogleCodeExporter closed 8 years ago
3
Unable to Maintain Stable Yaw.

#183 GoogleCodeExporter closed 8 years ago
7
Version numbering problem. Version 2.0.12 announced instead of 2.0.22.

#182 GoogleCodeExporter closed 8 years ago
1
Improvement to Sonar pitch/roll compensation algorithm

#181 GoogleCodeExporter closed 8 years ago
13
MAVLINK does not send battery_remaining (Correct in APM code)

#180 GoogleCodeExporter closed 8 years ago
1
Auto mode protection

#179 GoogleCodeExporter closed 8 years ago
2
Camera Stabilizer

#178 GoogleCodeExporter closed 8 years ago
10
PWM output during firmware Upgrade

#177 GoogleCodeExporter closed 8 years ago
10
Reset Compass offsets on "compass off" in setup

#176 GoogleCodeExporter closed 8 years ago
3
Configurable indication of 'motors armed' state

#175 GoogleCodeExporter closed 8 years ago
1
Altitude hold variable not initialized

#174 GoogleCodeExporter closed 8 years ago
1
control in STABILIZE mode

#173 GoogleCodeExporter closed 8 years ago
3
ATTITUDE is not properly logged with "enable all" in logs

#172 GoogleCodeExporter closed 8 years ago
1
remove all motor_out[CH_3] from motors_tri

#171 GoogleCodeExporter closed 8 years ago
3
Saving Mag Offsets on motor disarm

#170 GoogleCodeExporter closed 8 years ago
4
Cannot read Logs - MSG "Bad log #"

#169 GoogleCodeExporter closed 8 years ago
4
Missing definition of GPS_PROTOCOL_AUTO

#168 GoogleCodeExporter closed 8 years ago
1
"Battery" command in Settings CLI behaves incorrect/confusing

#167 GoogleCodeExporter closed 8 years ago
4
Enable motor mount LEDs by default

#166 GoogleCodeExporter closed 8 years ago
3
read_radio should move to fast_loop()

#165 GoogleCodeExporter closed 8 years ago
3
we are using g.rc_3.radio_min for all chanels in output_min() function

#164 GoogleCodeExporter closed 8 years ago
2
(enter short description of requested enhancement here)

#163 GoogleCodeExporter closed 8 years ago
3
Integrate Audible Alert Code

#162 GoogleCodeExporter closed 8 years ago
3
error in AP_GPS_NMEA.cpp

#161 GoogleCodeExporter closed 8 years ago
1
Yaw control could not perform smooth and correctly for both TRI and HEX

#160 GoogleCodeExporter closed 8 years ago
9
Radio input only for about half move of the stick.

#159 GoogleCodeExporter closed 8 years ago
14
Yaw stick input problem

#158 GoogleCodeExporter closed 8 years ago
7
Loosing CH3 input after rebooting APM 2560

#157 GoogleCodeExporter closed 8 years ago
12
MAVLINK_MSG_ID_PARAM_REQUEST_READ

#156 GoogleCodeExporter closed 8 years ago
2
ACM2.0.6 download file is 40.9MB

#155 GoogleCodeExporter closed 8 years ago
2
Compile error if MOTORS LEDs ON.

#154 GoogleCodeExporter closed 8 years ago
2
comma missing in test_battery function

#153 GoogleCodeExporter closed 8 years ago
1
Quad yaw control

#152 GoogleCodeExporter closed 8 years ago
3
APM forgets PLUS frame setting on 2.0.6 beta

#151 GoogleCodeExporter closed 8 years ago
2
Manual error

#150 GoogleCodeExporter closed 8 years ago
3
MN error

#149 GoogleCodeExporter closed 8 years ago
2
Update APM_Config.h.reference to be more relavent

#148 GoogleCodeExporter closed 8 years ago
4
safe for Altitude mode

#147 GoogleCodeExporter closed 8 years ago
2
Xbee getting bricked by new Tricopter firmware

#146 GoogleCodeExporter closed 8 years ago
7
Yaw issues when using compass

#145 GoogleCodeExporter closed 8 years ago
4
Support for motor-mount LEDS as in NG code

#144 GoogleCodeExporter closed 8 years ago
3
R2280 not works for hexaP

#143 GoogleCodeExporter closed 8 years ago
5
Control issue

#142 GoogleCodeExporter closed 8 years ago
11