-
Hi, first of all thanks for the work performed with regards to hardware PWM for the RPI.
I have a 12V ledstrip controlled with a pwm module that wasn't very usefull due to the flickering of the softw…
-
Hello.
I want to make DİY_ESP32 with NodeMCU ESP32s.
I used L298 as motor driver.
Where should I connect the CH_PWM_L1/ L2/R1/R2 and PIN_PWM_LF1/LB1... pins? I don't understand this.
When CH_PWM…
-
I have an CMP 40HX msi afterburner doesn't seem to provide any voltage control for this gpu can anybody help?
-
#### Arduino Mbed OS RP2040 for Raspberry Pi Pico - Version 3.5.4
In exploring the use of *analogWrite()* and *digitalWrite()* on the Raspberry Pi Pico using Arduino, I have discovered some strange…
-
Some of the DIO support PWM. Add SCPI commands to configure and enable PWM on individual DIO channels.
-
/sys/class/pwm is there, but I am missing pwmchip0? I am attempting to give pwm commands through pwm to control a servo.
-
## Bug report
Reporting a minor issue with motor direction with 3D enabled BL_HELI compatible ESCs. Observed with Bluejay and AM32 firmware, both DSHOT600 protocol. Can be fixed by changing ESC to "3…
-
Thanks for making such a great product.
As a customer I love to have my 3d printers on standby so I can print without having to walk into another room.
However having the printer fan constantly …
-
I was thinking about controlling FAN Speed. The only thing you need is one GPIO put in PWM mode and a fan with PWM control. And of course a few commands ie. : PWM_SETFREQ, PWM_SETRANGE, PWM_VALUE. An…
KPK75 updated
7 years ago
-
It seems the nominal operation of the AMDC is with SiC power stacks which can switch much faster than the control rate of the C code (e.g. control rate `1/Ts = Fs = 10kHz`, PWM switching freq `1/Tsw =…