-
Based on Marlin-bugfix-1.1.9
Command G5 no longer needed vor powerloss recovery, now using Marlins powerloss function
Cleanup ANYCUBIC_CHIRON_1.3.0 surcecode to save SRAM.
Add files chiron_lcd…
-
Hi. is possible use TMC2130/TMC5160 in SPI mode?
greetigs
-
The way that fluidnc wants uart channels to be set up has changed, see [this page](http://wiki.fluidnc.com/en/config/uart_sections) of the wiki.
> Trinamic UART devices like TMC2208 and TMC2209 no…
-
I've got a Koonovo Elf (Same as Creativity Elf), with no modifications. I want to upgrade all stepper drivers to TMC2208 in UART mode, as well as add a bltouch. I've found a document here: https://www…
-
When we set the currents on our uStepper S-Lite boards , they do not appear to be working as expected. While the TMC2208 reports the current setting that was intended, the motors are running hotter t…
-
![image](https://user-images.githubusercontent.com/3938103/60772758-6e70d780-a12d-11e9-9fcd-26f94addc41e.png)
Already install driver from Virtual COM Port driver folder, still the same.
-
I want to connect 2 TMC2209 to arduino ,
when i send 1 in serial just one stepper worked wich have address 0b00 the otherone with ADD 0b11 not worked , however MS1 MS2 with Vio for Add 0b11
this…
-
-
One of the Y axis moves slower than the other causing issues during prints. I have no clue where to go from here.
`/**
* Marlin 3D Printer Firmware
* Copyright (c) 2019 MarlinFirmware [https:…
-
In the current implementation of the system, the sound produced by the stepper motors of the lung system is audible and sometimes distracting from the sound actually being produced by the recorder. On…