-
I have my home built laser running with the iMXRT1062 Driver. I wanted to try out PPI, but not sure how to get it going in light burn. Would it be possible to try your version of the iosender for your…
-
I try to use laser scan of hokuyo lidar uam-05lp-t301 but it say I could not open ethernet port
192.168.1.10:10940 could not open ethernet port.
then I try to ping 192.168.1.10 make a check that…
-
@beniroquai
- Wir sollten noch die BOM einfügen?
- Soll ich noch etwas zum Aufbau des Setups schreiben?
- Wahrscheinlich wäre eine kleine Einleitung zum ImSwitch GUI ganz gut. Die installation…
-
```
What steps will reproduce the problem?
1. Activate laser sight
2. Shoot from sniper rifle
What is the expected output? What do you see instead?
I should be able to shoot second time with sniper r…
-
```
What steps will reproduce the problem?
1. Currently initial substates are marked with a color different from other
substates.
2. We can save the statechart as a PNG file and print it out using l…
-
```
What steps will reproduce the problem?
1. We are using printHTML
2. Printed only "Hello World"
3.
What is the expected output? A single page that says "Hello World" What do you
see instead? We …
-
```
What steps will reproduce the problem?
1. We are using printHTML
2. Printed only "Hello World"
3.
What is the expected output? A single page that says "Hello World" What do you
see instead? We …
-
```
What steps will reproduce the problem?
1. Activate laser sight
2. Shoot from sniper rifle
What is the expected output? What do you see instead?
I should be able to shoot second time with sniper r…
-
#### Issue details
When using a laser altimeter and the "Terrain" option in mission planner, We have found that if the drone transits over water (pond) the drone will enter RTL.
This is due to the r…
-
This could enable the usage of cutting in a sort of dot mode, where "secretly" the laser isn't on continuously but is turned on and off very fast. Because a lasercutter is more powerful when it's just…