-
I have carefully measured this in Netfabb, and noticed it when I printed out the felt branch. Distance of motor centre (or Z-leadscrew centre) to Z-rod centre on Z-motor-mount = 30mm, same distance on…
-
All motors planned for the robot re implemented in code right now, but as of now, they haven't been tested with the actual hardware. Note that this is dependent on wiring and build hooking up the moto…
-
Here is my use case:
The SimplePWM does create a pwm for a motor. At the start of the pwm cycle the motor is enabled. A millisecond after this event I want to measure the current of the motor with AD…
-
The project code bldc.x doesn't completely initialize the unused ports and correctly terminate them in to weak pull up or down
On **mclv-48v-300w** J11 (XPRO1 Header) Pin 16 - If you touch PI…
-
I'm working on a Python-based GUI program. A button on the main window connects a slot
called on_btn_start_clicked(). I want to scan a z-stack with Thorlabs Kinesis Stage. So I created a threading t…
-
Hi.
Would it be possible to add a way to control a Motor -> Backwards / Forward? Connected to GPIO?
-
What is wrong with my device? I would take a look into the sourcecode (for what GitHub is all about - sourcecodes) myself, but you have first to publish it here.
With the misfittech stepper control…
-
-
There are some situations where it is necessary to disallow redefining the position of an axis with an absolute encoder.
This can be done at the driver level for model-3 motor drivers:
https://g…
-
this is an old issue, we just ran into it again this time: the sign of the backlash value seems to be following the dial rather than the user value, which is a bit counter intuitive. We think about bl…
dlzhu updated
3 years ago