-
Hello,
I'm reporting an issue I experienced, hopefully it will help someone out, or a fix can be included.
## Bug report
**Issue details**
I was experiencing a problem with 4.0.5 ArduCop…
-
I seem to have some issues with BLHeli32.6.1.
Betaflight 4.0, Aikon AK32 6S ESC's, 2x470uF low-ESR cap on the power rails, 2450kv Hypetrain motors, 5S battery, motor_output_limit = 75 in Betaflight, …
-
This is a list of known issues especially blockers for the 4.1.0 rover release. The equivalent Copter issue is https://github.com/ArduPilot/ardupilot/issues/16478
Issues requiring investigation:
…
-
Hello :)
I am coming from iNav and noticed BetaFlight does not support the Naza GPS protocol (which uses one UART for both "GPS and Mag") which I think is kind of sad (already using SoftSerial for …
-
## Current Behavior
To use RPM filter, the ESC telemetry must be connected to the flight controller.
## Desired Behavior
Most ESCs with BLHeli_32 and BLHeli_S are supporting bidirectional DShot. …
-
When trying to use Reversable Shot motors with rover firmware the reverse values are inverted.
0-100% forward should be 1500-2000us output and that works fine.
0-100% reverse ends up as 1000-1500…
-
### Describe the bug
Hi everyone, I have a mamba F722s MK2 flight controller, which I bought around 2019. I recently flashed the latest version of betaflight firmware and found that whenever the flig…
-
Hi,
Our lab is developing a Simulink block to access Beltaflight in hardware-in-the-loop simulations:
 (all pins double checked)
- no device detection
-…
-
Betaflight 4.0.3
Omninext F7
Airbot Furling32 mini
Rev32.6.4
Motor 3 will not start.
I could make one flight. After 15sec Motor check, than I wanted to start again.
Motor 3 did not want to tu…