-
Bug report
Issue details
I am experiencing an issue with the configuration of my flight controller and RTK system. The copter only arms in Stabilize mode and fails to switch to other flight modes …
-
We need to find an alternative way to fetch it besides using https://mavlink.io/en/messages/ardupilotmega.html#MAV_CMD_DO_SEND_BANNER
Which replies as STATUSTEXT messages....
-
I have clone the repository via "git clone --recursive -b EuroGNC_2022_flight_test https://github.com/ybeyer/ardupilot.git"
but when the flight mode is switch mode 29, the quadrotor in sitl seems to …
-
Is it posssible to display both airspeed and groundspeed with arduplane? Airspeed indication only is not safe for long range flights .
Thanks.
-
I have one of these lidars on order and watching this project with interest.
It would be great if this firmware ends up in a state that flight controllers running Ardupilot could use, it very possi…
-
I used the following command for simulation, but the speed has been between 1~2m/s after takeoff
but I tried using skywalker_x8_quad, it worked fine
**gazebo:** gz sim -v4 -r alti_transition_run…
-
-
## Bug report
**Issue details**
After running my compiled executable for OBAL, the following error appears: SIGSEGV, Segmentation fault. (Everything is done according to OBAL's [instructions](http…
-
This looks impressive, but lacks support for the largest potential user and developer base.
-
Hi Guys,ì I'm here again :)
I tryed to startup for the first time ardupilot but I'm not sure it's working. It looks like is stopping. Here the service file where I changed the config-pin option "-f…