-
## Expected Behavior
MANUAL_CONTROL messages should be sent with a regular interval when there is a joystick connected (or virtual joystick is enabled.
## Current Behavior
Every 30 seconds, somet…
-
I have connected Pixhawk directly to my linux computer over usb and the serial port is /dev/ttyACM0
When i run the code as
`python simplegoto.py --connect /dev/ttyACM0`
dronekit detects the firm…
-
Hi,
Below message is submitted on "0.0.0.0:8088/mavlink" URL and works well using SITL autotest tool
```
msg.payload = {
"header": {
"system_id": 1,
"component_id": 1,
…
-
Downloaded the latest stable release image from https://www.ardusub.com/resources/downloads.html#companion-computer-images and tried to upload it via the web interface. After the upload was finished, …
-
Hi,
Using mavlink2rest with ardupilot autotest, altitude information is available in AHRS3 section. Data is updated regularly and correct.
Using physical BR2, this info is not available. Value is st…
-
## Expected Behavior
Unobstructed video.
## Current Behavior
"No GPS Lock for Vehicle" shows at the center of the video
## Steps to Reproduce:
Please provide an unambiguous set of steps to re…
-
The configuration is loaded, but I am not getting any data on the other side
```
root@companion:/# /home/pi/services/ardupilot_manager/main.py
Loaded settings from /root/.config/ardupilot-manager…
-
## Expected Behavior
QGC should display battery voltage
## Current Behavior
QGC does not show battery voltage
## Steps to Reproduce:
1. Use QGC 4.0.11 on linux
2. Use with Ardusub vehichle
…
-
## Bug report
**Issue details**
Not possible to change parameter GND_EXT_BUS, makes it difficult to use other boards.
**Version**
Ardusub > 3.6.1 (maybe also from 3.5.1)
**Platform**
[…
-
## Bug report
**Issue details**
When creating a custom frame motor 1 and 2 always spins the same direction even if you give them opposite commands
if I set up the frame like this. I expect gi…