-
### Board and Version
Matek F405-STD
INAV v.1.9.1
### Behavior
I connect the uninverted smart port pad of R-XSR receiver to TX port, and configure FPort as serial rx.
The RC link work fine, but…
-
Flash latest stable 2.6.0 to Matek F722-STD and no response in Receiver tab. Performed RX binding again just to be sure, although I did get the green light on teh RX9 Slim+ the first time.
I have…
-
### Is your feature request related to a problem? Please describe.
It is known, that the gyro origin offsets measured during the gyro calibration process are temperature dependent.
DJI drones heat t…
-
- [x] [Link Checker](https://validator.w3.org/checklink) にて https://chirimen.org/chirimen/gc/top/examples/ 内のリンクが壊れていないことを確認しておく
- [x] Raspberry Pi OS 32-bit 書き込む…書き込み中
- https://downloads.raspber…
-
**Describe the bug**
The new MPU9250 driver (> v1.10.0) missed detection of '_whoami' flag for 9250 & 6500, thus registered a false mag device class path even for mpu6500 chip who actually does not h…
-
chirimen-raspi3 環境のPolyfillと、chirimen環境に対応したそれぞれのデバイス用ドライバーをnpmパッケージにして、依存管理システムを導入する
- [x] リポジトリを配置する
- https://github.com/chirimen-oh/chirimen-drivers
- [x] gcディレクトリ以下のそれぞれのサンプルコード群に package.…
-
```
[FATAL] [1598722291.909609022]: initialize: Set mode for interrupt pin not permitted.
[FATAL] [1598722291.933906503]: write_register: I2C write failed.
```
-
## Current Behavior
The Imu don't work
## Steps to Reproduce
Just flash the firmware
## Expected behavior
MPU6500 should be detected and work, but it's not.
## Suggested solution(s)
I tri…
-
add support for stubbing nested modules on LEGO and M5STACK
see https://github.com/BradenM/micropy-cli/issues/43
-
## Current Behavior
Since INAV 2.5, Servos will full deflect (2000uS value) when a RX failsafe condition is met. It occurs with aircraft disarmed. I didn't test is in flight.
https://www.youtube.c…