-
I don't know how people have been routing the neopixel wiring, but the only way I see to get from the rear electronics area to the top of the build chamber is through the Y end stop switch cutout. Thi…
-
Hi,
Please consider adding a file named `LICENSE`, with the chosen license. If someone (like https://github.com/brianvoe in https://github.com/WINTFOX00/TRIDENT-STEPPER-DECOUPLER/issues/1) chooses …
-
I ordered OptoTap with the provided files (under OptoTap/Tap_Photosensor_PCB_v2/jlcpcb). The D1 LED are all placed upside down.
I contacted jlcpcb and they replied:
"Thanks for reaching out and so…
-
The Switchwire manual shows the diode and signal wire connection but just shows the positive and negative probe wires going to nothing.
![Screenshot from 2022-03-08 16-31-28](https://user-images.gith…
-
So I am liking my Klippain install now that I have everything setup properly(my overides page is way bigger than I thought it was gonna be lol)
But I had a couple Ideas, not sure how viable or hard…
-
Some Voron v1.8 manual PDF issues:
p.32, misspelled Gantry in the title of the chapter,
p.20, screws should be M5x30 BHCS
-
When previewing a sliced object and the filament you choose is black, it is impossible to see the lines in the output. I would suggest limiting the preview to a minimum level of gray so this does not…
-
(Response to https://github.com/VoronDesign/VoronUsers/pull/258#pullrequestreview-617054996):
> Please don't make changes in other people's directories.
@KiloQubit I understand why that's a poli…
-
Manual specifies M3 6mm. 8mm and 12mm With part which have old version of [a]_Tap_Center_r8.stl.
8mm and 12mm bolts are too short for current version.
In step file bolt lengths are 6mm, 12mm and 1…
-
### Which mod does this issue apply to?
printer_mods/LoganFraser/WagoMounts
### Relevant VoronDesign printer
On my V2.4
### Describe the bug
The Wago Extrusion Mounts collide with the Deck Panel …