-
An uninterruptible, fast stepper motor controller should not be used as a typical. Instead, a IO driver should be introduced. This creates a hardware specific object which can be controlled by the bis…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
btt skr 1.4 turbo, tmc 2209 drivers
### Bug Timeline
_No response_
### Expected behavior
…
-
-
Hi, i have a problem with this driver every time saying TMC CONNECTION ERROR
this is my configuration usin Marlin 2.0.6.1
[Marlin.zip](https://github.com/bigtreetech/BIGTREETECH-SKR-V1.3/files/5…
-
Hello,
Another question for stepper motors, is micorstepping used when driving the steppers? Is it possible to build a simple circuit using ULN2003 to power the motors, that is, without the driver bo…
-
the M119 reports either TRIGGERED or OPEN..
if it is OPEN and gets TRIGGERED it stays in the Triggered mode.
else it just stays in OPEN MODE.
the sensor i use is the https://in.element14.com/…
-
HI All,
I'm a complete novice when it comes to Steppers etc, but I'm a fair way through getting everything set up, but have no connection between spinning the encoder and seeing the stepper spin.
…
-
BigTreeTech SKR board.stl is wrong the outer connector of the stepper driver is 2.4mm too far in.
The two big connectors are (heatbed and 24Vin) are 1.3mm to wide
TH1 TH0 TB are 1.3mm too far to the…
-
since Stepper Drivers have got XH 6 pin connectors and there are two types of cables , but none of them are using tyco MTA.
here are the corresponding pictures:
Stepper connector XH , with securing.…
-
Hello,
i trying to build my own laser engraver with a custom choice of components (i'm a computer engeneering)
Now i'm testing the motion but i have some problem with acceleration: for each command …