-
Everyone, this is the changelog generated automatically by using [github_changelog_generator](https://github.com/skywinder/Github-Changelog-Generator), please review.
---
# Change Log
## [v1.8.0](h…
-
Continuation of https://github.com/iNavFlight/inav/issues/1781
-
// I don't know if this ist the right spot for this- if not, please correct me!!!
I want to have a new RTL feature for AIRCRAFT that does following:
**1st: If failsave is triggered then start cl…
-
Hello ,
I am trying to use my crazyflie with ROS. When i run the command "rosrun crazyflie_tools scan
" i detect the radio but not the crazyflie.all my rules files are set in place. What could be th…
-
### Board and Version
_Mactec f405std
_Inav 1.9_
### Behavior
* I can fly around in various modes, manual, pass through, positon hold and rtl all work as intended.
After a short flight sa…
-
It appears that the flying wing config only setup on one motor when it should setup 2 on outputs 1&2. Only output 1 shows the 'min throttle' setting. The rest show 0.
Output 3&4 should be the ser…
-
When I install iNav 1.2.0 stable on a Naze Rev6 7DOF, ( e.g. this one: https://www.aliexpress.com/item/New-Arrival-REV6-NAZE32-7DF-Flight-Controller-For-RC-Multirotors-Baseflight-Configurator/3259617…
-
Don't now, if correctly placed here and really relevant:
Noticed that in configurator/sensor the accelerometer readings are doubled on F4's (DYSF4PRO, REVO).
F3/F1's (LUX_RACE, NAZE) are OK.
My "fe…
-
I'll be flying along happily in a forward direction and I decide to punch full throttle - immediately if not sooner, the quad will do a backwards flip/stall and crash.
If I'm hovering and then punch …
-
I flash the latest 1.3 RC2 , because the earlier have a problem to detect the magnetometer (BMP280) on my naze. i think this issue may be corrected. but now
after 1 minute (aprox) the i2c error increa…