-
Hi,
I have an Issue with my newly arrived Beitian BN-880. The Magnetometer is recognised correctly and responds to turning it. The Problem is, it does not response when I turn it horizontally but w…
-
When I install iNav 1.2.0 stable on a Naze Rev6 7DOF, ( e.g. this one: https://www.aliexpress.com/item/New-Arrival-REV6-NAZE32-7DF-Flight-Controller-For-RC-Multirotors-Baseflight-Configurator/3259617…
-
While Gps works great and there are great options
V-Tail210 - SP Racing F3 Evo - Accelerometer -Magnetometer / OSD not available
not detected correctly and when i select still its not taken into…
-
Don't now, if correctly placed here and really relevant:
Noticed that in configurator/sensor the accelerometer readings are doubled on F4's (DYSF4PRO, REVO).
F3/F1's (LUX_RACE, NAZE) are OK.
My "fe…
-
I'll be flying along happily in a forward direction and I decide to punch full throttle - immediately if not sooner, the quad will do a backwards flip/stall and crash.
If I'm hovering and then punch …
-
I flash the latest 1.3 RC2 , because the earlier have a problem to detect the magnetometer (BMP280) on my naze. i think this issue may be corrected. but now
after 1 minute (aprox) the i2c error increa…
-
The first time a user starts our app he gets prompted to login, iff he choses not to, it pops up again 2 seconds after they close the login prompt.
This only happens once per Session.
I dont get a…
-
The [MPU6500 driver](https://github.com/PX4/Firmware/tree/master/src/drivers/mpu6500) configures the sensor not correctly, which will lead to bad flight performance. It has to be removed. Instead the …
-
http://www.mateksys.com/?portfolio=f405-osd
Tested it with betaflight had 5 usable uarts, neat attachement to power distribution board which has current sensor (FCHUB6s), OSD, SDCard Slot.
Looks…
-
Hello,
I need iNav to use the MPU9250 at its 'high' address.
-> Maybe address selection for the sensors could be implemented in the configurator ?
Setup :
(SPF3) (MPU9250 Module)
The…