-
Hello,
I have been having some issues setting up chrony on a MIR500. When it is installed, the laser scanners stop working.
I see that the commit https://github.com/DFKI-NI/mir_robot/pull/130/commit…
-
Hello @marcanpilami
Lorsque j'essaie d'appairer un scanner Zebra avec Mobiscan utilisant la bibliothèque enioka scan, je reçois correctement les signaux d'appairage CONNECTING et CONNECTED. Cepend…
-
I have a quite particular issue.
On my robot there are two lidar scanners:
- at the front, mounted upside down
- at the back mounted upright
I manages to merged them with this package, but t…
-
Hi,
tldr: I am searching for a method to switch between 64 constant values to use for multiplication in an instance value expression.
I have the data of a laserscanner (Hesai Pandar 64). The scann…
-
Lors du démarrage de Mobicop sur un Samsung Xcover 4, la bibliothèque démarre en mode scanner, bien que cet appareil ne devrait pas prendre en charge ce mode.
**Comportement attendu :**
L'applicat…
-
### Brief Issue Summary
Everything works just fine using version 1.13.45, but when switching to 1.14.x I'm no longer able to build. After configuration I get the following error:
`[rollbar] Unha…
-
this might be connected with #48
The response to the /field_data service contains for each field:
```
ranges: [0.0, 0.0, 0.0, 0.0, 0.0, 0.0, 1.069000005722046, 1.069000005722046, 1.06900000572204…
-
Hi,
Thanks for sharing this package.
I have a setup in which my lidar is mounted in vertical way, rotate 90 degree roll from horizontal axis.
I have tried this package with my setup, But it d…
-
Hello @marcanpilami
Après avoir mis à jour à la version 2.3.7, je constate un souci avec la configuration des profils DataWedge. Seul le Profile0 semble fonctionner correctement. Les autres profils …
-
Hello, we have a nano scan 3 mounted on our robot. However, when I move the robot, the laser scan (obstacles) rotates with the robot. There are two possibilities that could cause these obstacle rotat…