-
I am using Pixhawk Cube. During the gyroscope calibration, I get an error like below and calibration does not end.
gyro 1 (ID 682249) no matching uORB devid
-
The Sparkfun 9DOF_razor_imu that I have is not able to store the data on my sd Card which is a SanDisk Ultra 64GB MicroSDXC Class 10 Card. is there a problem with the SD card type or do i have to add …
-
Make IIS2MDC driver
Enable LSM6DSL Sensor Hub mode so that's the only IMU we need to talk to for getting accelerometer, gyroscope, and magnetometer data
-
Hi Kris,
I am using the MPU9250BasicAHRS and connected the following:
VCC - 3.3V
GND - GND
SCL -10k RESISTOR - A5
SDA -10k RESISTOR - A4
I am getting the following error:
![image](https://…
-
Hi, I have a problem with the LUA "Graupner Hott" script to configure telemetry ... the message "No Hott Telemetry" always appears
- I use an iRX4 Lite module on my FrSky XLite Pro radio
- I have up…
-
Please add this repository:
[https://github.com/adafruit/Adafruit_9DOF](https://github.com/adafruit/Adafruit_9DOF)
-
I am using a zed camera and external imu (razor_imu_9dof) the camera is getting calibrated. and when giving the calibrated camera cam chain file and imu.yaml it is throwing an run time exception
![S…
-
While Uploading my Arduino code I have these following Errors
```
Arduino: 1.8.7 (Linux), Board: "Arduino Nano, ATmega328P"
/home/hitesh/cart_ws/src/acs/razor_imu_9dof/src/Razor_AHRS/Razor_AHR…
-
### Subject of the issue
SFE_UBLOX_STATUS_CRC_FAIL errors with direct UART connection from NEO-M8P-2 to Feather 32u4 basic TX/RX (null-modem).
### Your workbench
Adafruit Feather 32u4 basic pr…
-
Hi Mark!
You did a good job ;) but looks like something wrong with madgwickFilter in 9DOF/main.py
**mx = mpu.my and my = - mpu.mx**
Please add notes to your code - i thought it was mistake
//…