-
**Overview of the Feature Request**
In order to improve the content of the proposed languages as a list of controlled values, and to be able to expose them with an identifier later on, we want to m…
-
**Right Now I have use your X-scara firmware.I know how to set INVERT my motor but I confuse what is the correct direction.I test on Pronterface and Repetier-Host.My Question is**
![move_in_position]…
-
all three marlin tango revisions seem to be the same 1.1.8 and seem to be setup for a delta.. i'm fairly new to marlin, and i am trying to get my new board running on a cartesian, and currently i am g…
-
One of the Y axis moves slower than the other causing issues during prints. I have no clue where to go from here.
`/**
* Marlin 3D Printer Firmware
* Copyright (c) 2019 MarlinFirmware [https:…
-
Hi . I wired everything like shown up but get TMC Connection Error in Display. Checked via Pronter 3 TMC2008 get a Connection But the 4. Has bad Response All to low. Can sw Help pls . I used BT…
-
### Description
sync scrape language with crowdin supported language
### Additional information
_No response_
-
I was able to attach my PandaPi to my Openbeam Kossel Pro, and all that's left is configuration. However, whenever I run G33, it consistently errors out with either "homing failed" (if I don't home fi…
-
A community member lets me know that he finished the Aragonese translation of the deed.
1. It's online at https://creativecommons.org/licenses/by-sa/4.0/deed.an etc., but **the language is not lis…
-
I'll try my best to explain this, the beta firmware you've provided, unless I've missed something, doesn't have the BigTreeTech 32 bit SKR V2.0 board, so I had to download the newest 2.0.9.2 marlin fi…
-
When trying to install bazarr from scratch, after unzipping the folder and doing the corresponding pip install successfully, I get the following error when running it:
```
Traceback (most recent c…