-
Two identical motors are used to steer and apply the brake on the 1/3 scale car. There is an arduino that needs to be programmed with the logic to turn the motors to achieve these goals. Basic motor…
-
When connected to a Control+ hub, my large spike prime motor works properly, but when connected to a Boost hub, even manually sliding the power slider does nothing on both c and d ports. I am using th…
-
As a user I would like to know that:
A) Beckhoff: If my relative encoded axis has no errors and has been "homed"
B) Galil: if my power check status is OK
C) all other MCs: if limits are not engag…
-
Hello @eddietheengineer
Thx for your work.
Can you please make version with motors outside the printing chamber? Like it was in https://github.com/FrankenVoron/IDEX
This will eliminate the n…
-
Likely going to switch the rudder odrive for a servo and keep an odrive for the sail (if mech team decides to keep the spool design).
According to [this equation](https://www.peachment.co.uk/torque…
-
I used a 2306.5 motor which still has plenty of power. It would be nice if the motor mount was an item that was bolted to the frame so different sized motors could be used. If I have to reprint my b…
-
### Variant
HOVERCAR
### Control type
FOC
### Control mode
Torque
### Description
How disable backward spinning motors? (Brake + fast accelerate)
-
This bit of code in stm32_mcu.cpp reads off the end of the pinTimers array if there is more than one motor. It doesn't always crash, which made it very difficult to narrow down where the problem was.
…
-
### Variant
None
### Control type
None
### Control mode
None
### Description
I have two 36V brushed motors, how can I modify the program to support brushed motors?"
-
The quad tailsitter is not shutting off the motors as soon the motors hit the ground.