-
Hi, thank you for your BESC
I expect this will help me but I don`t know where board data is.
I need this board data which is registered in .gitignore, so plz upload it if you don`t mind
-
This is not a firmware question, but I checked the new pages and I found some questionsI had mount a vesc 6 on the Cablecam. It work well, but:
1) have you configured on FOC mode or BLDC mode? (I'm u…
-
Does stmbl support sensorless control?
feiyg updated
6 years ago
-
I built a Racecar J and could use teleop to drive it. I found, however, my car always turn right a little bit, even when I drive it straight. I think the steering is not centered. Is there anything I …
-
Some applications do not require very precise positioning, but there are readily available motors with hall sensors. Example is hub motors for use with mobile robots.
-
Hi,
I am going to build a car based on the MIT racecar platform. I am constrained on budget, so I am trying to evaluate if I can cut down on the cost of the base platform. Hoping to get some help h…
-
Dear Werner, yesterday night I noticed during some test on the board that the **passthrough mode** is influenced from max speed control pot, but not from acceleration pot.
If I switch to **Passthro…
-
-
I can only imagine I must be wiring it wrong. I'm using a mega, with a 4.10 vesc running 2.16.
I have uart selected as the mode and baud rate is 115200 on the vesc.
I have vesc Rx -> Tx1 and ves…
-
We are using the following VESC library for being able to communicate with the VESC.
https://github.com/faraday-motion/bldc_uart_comm_stm32f4_discovery
Read more about what I used to implement this…