-
Seems as I'm using the editor sometimes the module will freeze up or I lose connection - and need to reset it. Is there a more graceful way to do this rather than brute force power cycling? I lose m…
-
Reported by Rick B.
1. Software bootup stability issue. Intermittent bootup requires cycling ‘RESET’ button to get stable connection
a. May power on with no MCU heartbeat LED
b. May power on with …
-
I need to do some additional testing to verify, but I believe if you dismount the SDcard, remove it, edit a profile, remount it without power cycling, load the profile, and click reflow; the heater do…
-
Hi,
today i tried to install pirrot on a Raspberri PI Zero W V1.1 with freshly installed
"Raspberry Pi OS (Legacy, 32-bit) Lite" (2023-12-05) from the Pi imager 1.8.4.
At the end every thing break…
-
Hi There,
A couple of weeks ago I bought and installed a doorbell-v3.0. After wiring everything up properly and configuring the thing through Home Assistant it seemed to work fine; testing was succ…
-
10:25 $ cd ~/Downloads/
pi@raspberrypi:~/Downloads$ pip install git+https://github.com/scikit-cycling/scikit-cycling.git
Collecting git+https://github.com/scikit-cycling/scikit-cycling.git
Cl…
-
Can you have a look at the email and documentation from Nico and figure out what we need to do to get their control and power cycling code working with our system?
First step will be to see how bi…
-
From bitcraze/discussions#1531: When the Crazyflie is compiled with one forced deck and a CRTP controller is used, the Crazyflie is not starting properly.
First step would be to reproduce this prob…
-
After flashing this build the unit comes up. But after the first power cycle it fails to boot. Based on serial output its a checksum error (bad flash), perhaps out of flash memory?
You can see me f…
-
## What is the feature?
Enable the "call for heat" on a boiler
### Description
I would like to be able to add my boiler control switch (in my case its a Shelly 1 Smart switch) into the Tstat …