-
Hi Hari, Thankyou for publishing your work on this. I've built a unit to run your code. See my fork for a few minor changes I made. I have the vario working pretty well and have been using it while fl…
-
with nmea navsat driver why when i launch,,,cannot show the latitude and longitude when i use ublox 7n for this package
what should i do to reedit this package so i can use this device correctly
-
1. Stratux version: 1.6r1-eu026
2. Stratux config: default
SDR
- [ ] single
- [x] dual
GPS
- [x] yes
- [ ] no
type: TTGO T-Beam v1.1 ublox NEO-M8N
…
-
### Board and Version
Matek F722-STD iNav 1.9.1
### Behavior
* when external magnetometer is connected the barro stops working, when I remove magnetometer the barro starts working again
The …
-
Hi I just received one of this:
TTGO T-Beam ESP32 868 MHz NEO-M8N GPS WiFi
it has a different gps module the Neo m8n, is it compatible or should I import a different library and compile source a…
-
As reported by Nick here: http://diydrones.com/xn/detail/705844:Comment:2099629
ARMING_CHECK = 0 does not override other checks.
I made these tests with ARMING_CHECK=0 and Stabilize mode, with PosHol…
-
Hi. I use LILYGO®TTGO T-Beam NEO-M8N for topographic surveys. I need to receive NMEA messages GGA, GLL, GSA, GSV, RMC, VTG. How can I do it? Can i used u-center or Arduino IDE?
Regards.
-
Hi. I use LILYGO®TTGO T-Beam NEO-M8N for topographic surveys. I need to receive NMEA messages GGA, GLL, GSA, GSV, RMC, VTG. How can I do it? Can i used u-center?
Regards.
-
**Describe the bug**
Using a MRO Dual N8N GPS,
(https://store.mrobotics.io/mRo-GPS-u-Blox-Neo-M8N-Dual-Compass-LIS3MDL-IST831-p/m10034-li8303.htm)
we have had vehicles on multiple occasions switch …
-
I have two machines running **master** , both configured with GPS_GNSS_MODE = 71 , so GPS+SBAS+GLONASS+GALILEO should be enabled on the GPS units.
On the Beitian BN-880, running on **COPTER**, gali…