-
```
What steps will reproduce the problem?
1. No overlay at all
2. video is ok from GoPro
3.
What is the expected output? What do you see instead?
I am only getting video from OSD. No overlay whatso…
-
Hi @TSC21 @dagar ,
We am trying to establish the px4 ros2 bridge using serial communication. We tried the following versions but RTPS build for the fmu-v5 fails.
Can you please point us to the …
-
**PX4 1.13.2, cube orange/jetson xavier companion computer, quadcopter 4.9kg**
Hi all,
I've had a crash with my drone whilst flying in position mode with RC (without using the companion computer)…
-
Currently, the mavesp8266 library takes support of older version of Mavlink. The problem is that if a custom ground control software uses Mavlink v2.0, it needs to detect the older version and change …
-
Hi,
I bought a Pixhawk 5x. I connected the motors, but only the motor connected to MAIN1 spins. MAIN2-4 is not sending the command.
It is as if it was the only output that is working. When I plu…
-
**Describe the bug**
In offboard mode, drone was able to arm and take off without valid local position, after taking off, EKF2 became crazy and then result in crash.
**To Reproduce**
Arm and take…
-
I use "Silicon Labs CP210x USB to UART Bridge (COM6)".
/////////////////////////////////////////////////////////////////////////////////////////////////////////
step1. connect Serialport - success…
-
**Describe the bug**
I am trying to set up and testing RTK GPS Heading with Dual u-blox F9P https://docs.px4.io/master/en/gps_compass/u-blox_f9p_heading.html with **SparkFun F9P boards**, PX4 **v1…
-
## Bug report
After a flight of about 3 minutes I get this message 'Internal error 0x1000000'
Both in manual flight and automatic flight The flight controller is a cube blue with an AUTOPILOT boa…
-
I know there were two issues related to this issue and they have been closed. I was trying to follow them but I couldn't get what they did to correct the issue. specially the mhkabir one!
I follwed t…