-
~~The Booster supports Waila but not TOP. Also,~~ the following blocks support TOP but not Waila:
- [x] Ender Monitor
- [ ] Endergenic Generator
- [ ] Timer
- [ ] Power Relay
- [x] Locator
- [x]…
-
### Cura Version
5.4.0
### Operating System
Windows 10 Pro
### Printer
Creality Ender 3 Pro/ Ender 3 V2/ Ender 3 Neo
### Name abnormal settings
Set to Tree Supports, 20 Percent infill, with hex…
-
### Description
Replaced the stock Creality board with the SKR mini E3 v2.0 on my Ender 5.
After the install used the firmware for Ender 5 (https://github.com/bigtreetech/BIGTREETECH-SKR-mini-E3/blo…
-
I have just installed SKR 1.4 turbo with a TFT 35 V2.0, on my Ender 3 Pro, got everything set up correct i think, It prints great until about 65 to 99% and just stops, no message on the screen, bed an…
-
I see that this board also has the TFT pin header on it.
I have the factory / stock CR-10S Pro Touchscreen working on the SKR v1.4 Turbo.
It should be possible to get the very same touch screen …
-
I for the life of me cannot figure out the issue I am having. I am attempting to upgrade my ender 3 with a Manta EZ3 and the board resets any time the fan and heater are activated at the same time. I …
-
**Server Log:** _(Use [Pastebin](http://pastebin.com/) or [Github Gist](https://gist.github.com/))_
No errors.
**FML Log(s):** _(Use [Pastebin](http://pastebin.com/) or [Github Gist](https://gist.git…
-
Ender Chest Minecart and an Ender Tank Minecart (hopefully compatible with railcraft fluid loaders).
Possible ways to change frequency:
- GUI
- Shift-right clicking with coloured tank/cart held in ha…
-
If you have a circuit with an ender pulsar on it and you use creatives mode pick block to duplicate the block it will freeze the state of the ender pulsar.
How to reproduce:
1. Go into creative …
ghost updated
7 years ago
-
Like the title says. If you move a conduit that has a connection to another that is not moved and it results in a break. The blocks do not visually update and appear showing their connecting faces wit…