-
Sometimes the simulation seems to run much slower. I've been able to isolate it that if you launch a drone a 2nd time, the ardupilot does not speed up after "Ready to Fly" When in the first run it goe…
-
Hello people,
Because I'm updating the UM and ready to release the modes page, can somebody clarify what is the behavior of Take off and Landing MODES for:
Take off FW:
Once activated does it s…
-
**I am not sure where this issue originates, I'm not an expert, but I cannot track down the cause.**
I apologize for all of the formatting and text, I tried to be as concise as I could.
**SETUP:**
…
-
Thanks for putting this up to date page and your wiki page explaining how to install the firmware.
However, I've found nothing on how to connect the LRS JR module to the Taranis.
I have the DTF-UHF …
-
I'm getting this weird crash since updating to V19 of Chromaticraft. I have to admit I didn't see it in V18b because I didn't explore so much back then. I'm flying around with a RoC winged Jetpack and…
-
So far we've had more than a 100 missions in VTOL. About 70 on 1.3.4 and just recently about 30 missions in 1.5.0RC1.
Paralel to this we are flying regular FW and have pretty decent amount of mission…
-
Hi,
Found something weird on my build, not sure if it's just me or someone see the same happens.
Whenever I click 'save and reboot' on failsafe tab, the value of failsafe_recovery_delay resets t…
-
Hi,
I have a freeze problem
Hardware: SP F3 EVO, Graupner Hott GR-16 receiver
Software INAV 1.7.0
If I connect the GR-16 Hott telemetry with the diode to the FC (Flight Controller), the contro…
-
I have iNAV 1.6 in my glider on a SPRACING F3 Acro. ESC is calibrated but it is not using the motor for RTH and so against wind it can´t make it home. I am new to iNAV so maybe I have just made a mist…
-
It seems to me it would be useful to have a single place to record incremental test successes (and failures) on the road to next release. It may also help catch regressions. If you disagree, please cl…