-
[AHRS Fusion With Two Adafruit LSM6DSOX + LIS3MDL Sensors Simultaneously](https://forums.adafruit.com/viewtopic.php?f=8&t=192892&p=933150#p933150)
I am working on generating AHRS data (see https://…
-
I haven't compiled or tested, just reading the code. See the marked lines in the code below. You are reading the raw mag bytes into the tmp array starting at index 1, and then using tmp[0], which do…
-
In newer 1.2 PinePhone board revisions LIS3MDL magnetometer was replaced by
AF8133J. They use the same PB1 pin in different modes.
LIS3MDL uses it as an gpio input to handle interrupt.
AF8133J us…
-
Board: [FeatherSense](https://learn.adafruit.com/adafruit-feather-sense)
Magnetometer : LIS3MDL.
SW: [feather_sense_sensor_demo.ino](https://github.com/adafruit/Adafruit_Learning_System_Guides/blob/…
-
The `read()` member function which is also used by `getEvent()` calls `getRange()` which reads the value over the i2c bus:
https://github.com/adafruit/Adafruit_LIS3MDL/blob/d162c5759bfab9ed707fa89b…
-
リスト:
- 今使っているGPSモジュール
- 製品: [Micro M8N GPS](http://www.holybro.com/product/micro-m8n-gps/)
- GPSチップ: [ublox M8N](https://www.u-blox.com/en/product/neo-m8-series?lang=ja#tab-product-selection…
-
Thank you for writing this driver and making it available.
I have a suggestion that I think will improve the usability of this driver.
It can be useful to separate ESP-IDF drivers into two repos…
-
Hi @jremington,
Following along a similar vein to #6, I would be interested to get your thoughts on the current (2024) selection of IMUs available from Adafruit.
In my application, I am deployin…
-
After removing the stm32 tone_alarm driver, the external magnetometer no longer showed up
(ls /dev/ only showed mag0)
After re-enabling the stm32/tone_alarm it re-appeared.
External GPS/Compas…
-