-
Make discrete lanes for wires from rails to components, and from protoboard to Roboclaws.
r i g h t a n g l e s
-
Awesome project! I'm looking to take a crack at building Doggo, but as $3k is a lot for a humble hobbyist, I'm looking to cut costs/reuse parts I already have. It'd be great to know _why_ you chose ce…
-
-
**Electrical Assembly Instructions / 2 Component Integration and Testing /
2.1 Power Distribution System:**
"1. Begin by powering the board. In order to do this we will be bypassing the switch an…
-
The revised Body Build Doc.pdf shows the monolithic control board hanging from the top of the rover with the R Pi hang down. The BATTERY IN is near the Differential Pivot Block. (An issue is noted w…
-
Calibration update & issue
The Calibration document refers to a program Ion Studio at
http://www.ionmc.com/downloads.
This link redirects to
http://www.basicmicro.com/downloads
and the program…
-
Hello to all,
I'm part of a project, where our task is to build the rover.
Our problem is that we have several problems with the Raspberry Pi and the controller.
While trying to run the codes an…
-
I would like to suggest adding the extra encoder wires for the corner steering motor.
This will allow both the absolute encoder to be used or the motor mounted encoder.
In the latter case I am going…
-
Here's the **Weekly Digest** for [*PX4/Firmware*](https://github.com/PX4/Firmware):
- - -
# ISSUES
Last week 52 issues were created.
Of these, 13 issues have been closed and 39 issues are still ope…
-
I've received the REV-C board, and these are the following revisions to be made:
* All coupling capacitors are connected to the voltage side of powering components instead of GND. They will all n…