-
Hi,
Just got the MKS Tinybee with an MKS TFT35 screen and A4988 drivers. I connected them up with 3 motors for testing but I'm unable to make the motors move with the default firmware as it came with…
-
When I run the command 'sudo IP link set can0 type can bitrate 1000000 loopback off', an error message 'Cannot find device can0' is generated. I don't know how to solve this because I am a beginner an…
-
Currently we are using the large Ethernet shield to control the motors.
All this board does is translate Ethernet to CAN for the motor shields.
- [ ] implement the motor driver CAN protocol on the…
-
Got sensorless homing working fine with FYSETC TMC2240 and the following config:
[tmc2240 stepper_x]
spi_software_mosi_pin: PB15
spi_software_miso_pin: PB14
spi_software_sclk_pin: PB13
cs_pin: P…
-
GanttStart: 2019-09-26
GanttDue: 2020-01-25
Write a simple arduino sketch to control the motor driver and spin a motor.
- [ ] Wire up the arduino, driver, and motor
- [ ] Write an arduino sk…
-
Commands:
- Drive
- Joysticks
- Turn X Degrees:
- gyro, motors, joystick
- Go Straight:
- gyro, motors, joystick
- Score (Work With Elevator and Manipulator) (Align)
- motors, vision,…
-
It would be great to explore a fuse to prevent the motor drivers burning out when e.g. the chain wraps and the sprockets get stuck as suggested here: https://forums.maslowcnc.com/t/a-jam-burnt-the-mot…
-
## Describe the bug
I am trying to control the motor [iHSV60](https://www.jmc-motor.com/product/102.html) but I'm getting the following error when calling the **/init** service. The configuration I'm…
-
Hi, my name is Alexis! I'm a research assistant and this is the first time I've worked with instrument fabrication. I have a few questions regarding the design and build for this microscope. I was won…
-