-
I am building a F550 Hexacopter with an Omnibus F3 v1.1 FC board. I flashed it with the latest version of INAV 1.91. My problem is, I can not get motors 5 & 6 to work. I tried motor pins 5 & 6, and al…
-
Currently the Multi-copter land-detector relies on thrust values which represent the actual system thrust limits with some safety margin. The hover thrust and minimum thrust are used to determine if t…
-
Im sorry my comment didn’t come through.
I have a betaflight f4 board and trying to get the rssi working from a l9r receiver.
I have enabled analogue rssi and tried to invert and still don’t get…
-
I was Getting up to 18 sats and flying well but after RC4, the GPS coordinates DO display and cycle with different numbers as if it’s trying to get a sat fix, but it never even gets 1 satellite fix. N…
-
While testing the v1.6.5 of the PX4 Firmware I discovered that in the stabilized mode the manual overwrite is not allowed:
https://github.com/PX4/Firmware/blob/master/src/modules/commander/commander.…
-
Condition: SP3 EVO board, fully functional quadcopter with RTH failsafe procedure
**Test**
Take props away, power on the quad and the TX, arm the quad, raise thrust to about 50%, then engage Fails…
-
### clracing f4air v2
inav 1.9
### Behavior
osd cut out on flight but sats remained and still had control..rth and functions still worked
VIDEO
https://youtu.be/2wF7qq-CWng
Entering CLI …
-
I have an SP Racing F3, most likely a clone. I have been fighting a GPS issue for a couple of weeks. I have tried 3 different SP Racing F3 boards and 3 different GPS units with similar results. Here…
-
@RomanBapst Could you please have a look at this log file?
https://review.px4.io/plot_app?log=6fa2399a-ccb4-4a2d-8303-091dec28dda0
@PX4/testflights You can tag Roman for future issues directly.
-
### Board and Version
_Mactec f405std
_Inav 1.9_
### Behavior
* I can fly around in various modes, manual, pass through, positon hold and rtl all work as intended.
After a short flight sa…