-
The parameters from connected UAVCAN nodes should each appear under a different heading per node.
Instead it's all mishmashed under Default Parameters and impossible to use.
@pavel-kirienko will b…
-
## Describe the bug
I'm currently using PX4 Firmware v1.13.1, tested with different flight controllers (CubePilot CubeOrange and Pixhawk 4). I have set the SENS_EN_LL40LS to I2C and SENS_EN_IRLOCK to…
-
Any Ublox with RAW data capability can be used for precise time measurements with sub-microsecond resolution using the external interrupt on the GPS module. This will be really good to timestamp each …
-
**Platform**
[ ] All
[ ] AntennaTracker
[ X ] Copter
[ ] Plane
[ ] Rover
[ ] Submarine
Is there other way to read and send the data from pixhawk to companion computer without using mav…
-
Modul datalogeru byl již několikrát použit na balonových letech v kombinaci s moduly [GPS02](https://github.com/mlab-modules/GPS02), [ALTIMET](https://github.com/mlab-modules/ALTIMET01) a [ISM02B](htt…
-
### Describe the bug
Using the VectorNav driver in EKF2 disable mode, the airspeed sensor reports a failure after a short period of time since flight begin.
### To Reproduce
Configure PX4 to…
-
i was testing to see if the esc calibration is OK ( I used a pixhawk board on DJI s1000 vehicle)
the motors didn't start until after 50% throttle
after that i couldn't disarm
i tried many times b…
-
## Bug report
new() expects exceptions, and we compile without them, and so when any compiler optimisation level above -O0 is used, godbolt shows that some did-new-return-nullptr checks are elided …
-
Hello, I flashed esp-link on an ESP01 device, trying to communicate with an arduino board trough a ground station (Mission Planner), I can connect easily in TCP on port 23, but would prefer to use UDP…
-
Hello,
Could you please help me to found what commande is send by mission planner to MAV when we click on "point camera here" ?
Thank you for your help.