-
When my delta homes it will stop one or more axes short of the endstop, then does its back off, and on the retest it starts for the endstops again but often (not always) stops short. In the end, some…
-
**Short overview**
I found this library from your comments on `robotjs`, and this is _exactly_ the library I've been looking for (after fighting multiple bugs and patches with `robotjs`, I've gone …
-
**Right Now I have use your X-scara firmware.I know how to set INVERT my motor but I confuse what is the correct direction.I test on Pronterface and Repetier-Host.My Question is**
![move_in_position]…
-
^
src/module/temperature.cpp:2682:39: warning: ISO C++ forbids converting a string constant to ‘char*’ [-Wwrite-strings]
src/module/temperature.cpp:2685:38: wa…
-
Hi there i am new to all this programming stuff i have a mks sgen v1 with tmc2209 on x, y, z, e1, axis and lv8729 on e0 i am trying to get sensor less homeing to work and dual z motors z, e1
i am…
-
Hi, I am newer to learn icefall,I finished the training of tdnn_lstm_ctc, when run the decode steps, I meet the following error, I change the --max-duration, there are still errors:
, direct stepping and advanced ok enabled, buffer size increased to fit advanced ok…
-
I think a great way to improve even more the speed is the option to choose the amount of words shown by jetzt during the reading. I could choose for example to read more than one word at a time.
It wo…
-
Thanks for any help.
## Problem description
Visualizer works fine with Platform Version, just gives a blank white window in Classic version.
### Expected Behavior
After loading a gcode fi…
-
Hi . I wired everything like shown up but get TMC Connection Error in Display. Checked via Pronter 3 TMC2008 get a Connection But the 4. Has bad Response All to low. Can sw Help pls . I used BT…